FULL CONDUIT WIRING SYSTEM OF A 2 BEDROOM FLAT ON BOARD  

2009-10-21
This project reports the installation of a conduit wiring on board that can be used as teaching aids. It"s operation is based on power supply from main it is design ...

DISIGN AND CONSTRUCTION OF DIGITAL OPERATED CEILING FAN REGULATOR  

2009-10-22
A digital ceiling fan regulator is a switching device, consisting of a multiple output transformer and multiple pole switches. Its functions is to control or regulate the flow of current ...

DESIGN AND CONSTRUCTION OF DC MOTOR CONTROL USING A SINGLE SWITCH  

2009-10-23
This project report presents the Design and construction of DC Motor Control for Forward and Reverse Direction that can be use to drive toy cars.

DESIGN AND CONSTRUCTION OF WIRELESS MICROPHONE  

2009-10-23
This project is aimed at making an impact or breakthrough towards the technological advancement, which serves as a basis for any meaningful development of the nation. The main objective of ...

DESIGN AND CONSTRUCTION OF SOLIDSTATE REMOTE CONTROL SWITCH  

2009-10-23
Remote control facilitates the operation of incandescent lamp switches around our home or offices from a distant. It provides a system that is simple to understand and also to operate, ...

DESIGN AND CONSTRUCTION OF AUDIBLE DIODE TESTER  

2009-11-02
The audible diode tester is an electronic device that allows flow of current to pass in only one direction anode to cathode, while in reverse bias it does not conduct. ...

DESIGN AND CONSTRUCTION OF 500WATTS A DC - AC INVERTER  

2009-11-02
Inverter is an electronic circuit for converting Direct Current (DC) to Alternating Current (AC) inverters is used in a wide range of application, from small switched power supplies for a ...

THE DESIGN AND CONSTRUCTION OF A LED LEVEL DISPLAY  

2009-11-02
This project report presents the design and construction of led level display for audio. The sound signal with a light emitting diode (LED) as an output in summary there are ...

DESIGN AND CONSTRUCTION OF AN HEARING AID  

2009-11-02
The aim of this project is to design and construct an hearing aid that can be used in developed and developing countries. 3V DC (2 x 1.9v battery). In this ...

DESIGN AND CONSTRUCTION OF A FULLY AUTOMATIC EMERGENCY LIGHT  

2009-11-02
The proposed project is the design and construction of a simple automatic emergency light has the following advantages over conventional emergency light. The charging circuit stops automatically when the battery ...